
Our shop is on Plunkett Street in Hollywood, so most of these jobs are a few minutes from the yard. Hollywood homes run from 1950s block houses near Dixie Highway to two-story homes in Emerald Hills and Hollywood Hills, to condos and older cottages close to the Broadwalk. Spray foam can transform how some of them feel. On others, it's money that would do more somewhere else.
Here's how we decide, what the work involves, and what it costs.
The question that decides everything: where are your ducts?
If your air handler and ductwork are in the attic — which is common in Hollywood homes built from the 1980s on — that equipment spends the summer in a 120°F+ space. Spraying foam on the underside of the roof deck brings the attic inside the conditioned envelope, so the ducts are no longer baking. That's where foam earns its price.
If your ducts run through interior chases or the air handler sits in a garage or closet, foaming the roof deck buys much less. A blown-in top-up on the attic floor with proper air sealing usually delivers most of the comfort improvement for about a quarter of the cost. See air sealing before insulation.

Open-cell or closed-cell?
Open-cell foam runs about R-3.7 per inch and is the common choice for attic roof decks. Closed-cell runs about R-7 per inch, resists water and works where space is tight or moisture exposure is high. We compare them for local conditions in open-cell vs. closed-cell spray foam in Hollywood.
What it costs in Hollywood
- Open-cell on the roof deck: $2.20–$3.80 per square foot installed
- Closed-cell on the roof deck: $3.50–$6.50 per square foot installed
- Removing old attic insulation first: $1.00–$2.00 per square foot
For a single-story Hollywood home with roughly 1,800 square feet of roof deck, open-cell typically lands around $4,000–$6,800 and closed-cell around $6,300–$11,700, before any removal. Full statewide ranges are in our Florida insulation cost guide.
Code and HVHZ notes for Broward County
Hollywood sits in Broward County, which is inside the High-Velocity Hurricane Zone of the Florida Building Code. Two things matter for foam work here:
- Thermal or ignition barrier. Foam plastic generally must be covered by an approved barrier. In attics that often means an approved coating. See Does spray foam need a thermal barrier?
- Ceiling R-values. Broward is in Climate Zone 1, where code calls for R-30 at the ceiling. Foam thickness should be specified to hit the target you're paying for.
Permits for insulation work are issued by the City of Hollywood's building division. Ask your contractor who is pulling it.
Humidity: the part people forget
A sealed attic changes how the house handles moisture. The attic is no longer vented to the outdoors, so the air conditioning system has to keep that space dry too. In a humid coastal city like Hollywood, that's worth planning for — some homes benefit from a supply register or a small dehumidifier in the sealed attic. The Department of Energy's insulation guide covers the basics, and our post on insulation and humidity in Florida homes goes deeper.
What the job looks like
- Assessment: we measure the deck, check duct locations, look at the existing insulation and note ventilation.
- Removal, if needed: old, wet or rodent-damaged insulation comes out first — see insulation removal.
- Prep: masking, protecting stored items, and closing off the work area.
- Spraying: foam applied in passes to the specified thickness, thickness checked as we go.
- Barrier and cleanup: approved coating where required, plus photos of the finished work.
Is foam right for your Hollywood home?
Good candidates: ducts in the attic, high summer bills, a house that never feels dry, a roof being replaced soon, or a plan to add a room. Weaker candidates: ducts already inside, an attic that just needs more depth, or a roof nearing the end of its life — do the roof first.
We give free assessments across Hollywood, Hallandale Beach, Dania Beach and all of Broward County. See our spray foam insulation in Hollywood page, or read about commercial spray foam in Hollywood if you own a building rather than a home.
Illustrations by Standard Insulation. Photos: Standard Insulation project photos from our Google Business Profile.




