
Insulation Removal in Sunrise
Here is the short version for Sunrise: we vacuum old, wet, moldy or rodent-contaminated insulation out through a hose to a collection bag outside — it never comes through your house — then air seal and reinsulate.
Removal is the first step whenever we find wet, moldy, compressed or rodent-fouled insulation in a Sunrise attic. The air handler and most of the ductwork sit in the attic, usually under R-19 to R-30 of blown fiberglass that has been walked flat around the AC platform and pushed aside at the eaves.
For most of these homes the best value is air sealing plus a top-up to R-38, a radiant barrier on the rafters and sealed duct connections. If the roof is being replaced, open-cell foam on the deck becomes a strong option.
Why insulation removal matters in Sunrise
Rats, roof leaks and storm damage all end the same way: insulation that is packed down, stained, smells and no longer insulates. Adding new material on top buries the problem. Removal gets the attic floor back to bare drywall so we can see and seal every gap.
Our removal crews use high-powered insulation vacuums, HEPA filtration and containment at the hatch. Once the attic is clear we sanitize where needed, air seal the ceiling plane and install fresh insulation to R-38. Mold remediation, where needed, is handled by licensed mold professionals under Florida law.
What's included
- Commercial vacuum extraction to bags outside
- Containment and floor protection at the access
- Rodent-fouled, wet and storm-damaged insulation
- Air sealing on the bare ceiling plane
- Fresh insulation installed the same week
What it costs
Removal typically runs $1.00–$2.00 per sq ft, plus reinstall. Every estimate is written and itemized — measured square footage, the R-value or thickness we will install, prep work and price — with alternatives side by side when there is more than one good answer.
Code & incentives
Sunrise homes are built and inspected under the Florida Building Code. For energy purposes all of Broward County is Climate Zone 1, where the prescriptive minimum for ceilings is R-30. We design to R-38 because real attics settle, get walked on and run thin at the eaves. Broward County is also part of the High-Velocity Hurricane Zone, so roof-deck work is always coordinated with the roofing approvals.
Electric service in Sunrise comes from Florida Power & Light (FPL). Insulation incentives change, so we check current programs before quoting — start with Florida Power & Light (FPL). For permits tied to remodels, additions or re-roofs, see the Broward County government. You can confirm any contractor's license on the Florida DBPR license search.