
Blown-In Insulation in Wilton Manors
If you live near Wilton Drive, you have probably felt it: the back of the house runs warmer, the AC never quite catches up and the bill tells the rest of the story.
Blown-in fiberglass is our most-installed product in Wilton Manors because it fills around trusses, wires and odd framing the way batts never will. Older homes have plaster or board ceilings, odd framing, flat roof sections and sometimes knob-and-tube remnants that must be evaluated before anything is covered.
We work carefully: inspect wiring with your electrician where needed, seal the ceiling from above, and choose materials that respect the building — blown fiberglass in open attics, foam on flat roof sections, nothing that traps moisture in old masonry.
Why blown-in insulation matters in Wilton Manors
Loose-fill fills around trusses, wiring and the odd framing in a hip-roof attic far better than batts can. The catch is coverage: blown insulation only performs when it is installed to the bag-chart depth and density, with no bare spots at the eaves and no voids behind the air handler.
We blow from a truck-mounted machine with the hose run through the attic hatch — nothing tracked through your living room — and we mark the depth every few hundred square feet. Fiberglass resists moisture and does not feed mold; cellulose packs a little more R per inch and dampens sound. We will tell you which fits your attic.
What's included
- Blown fiberglass or cellulose, matched to your attic
- Installed to manufacturer depth and density
- Hose run from the truck — no bags through the house
- Pairs with air sealing and radiant barrier
- Fast: most attics done in a single day
What it costs
Typically $1.10–$1.90 per sq ft for fiberglass to R-38, depending on starting depth, access and air sealing scope. Every estimate is written and itemized — measured square footage, the R-value or thickness we will install, prep work and price — with alternatives side by side when there is more than one good answer.
Code & incentives
Wilton Manors homes are built and inspected under the Florida Building Code. For energy purposes all of Broward County is Climate Zone 1, where the prescriptive minimum for ceilings is R-30. We design to R-38 because real attics settle, get walked on and run thin at the eaves. Broward County is also part of the High-Velocity Hurricane Zone, so roof-deck work is always coordinated with the roofing approvals.
Electric service in Wilton Manors comes from Florida Power & Light (FPL). Insulation incentives change, so we check current programs before quoting — start with Florida Power & Light (FPL). For permits tied to remodels, additions or re-roofs, see the Broward County government. You can confirm any contractor's license on the Florida DBPR license search.