Broward · Miami-Dade · Palm Beach — Licensed & insuredbids@standard-insulation.comOpen 24/7 · (561) 975-6204
STANDARDINSULATION · SOUTH FLORIDA
Palm Beach County

Attic Insulation in Palm Beach County.

Most of the heat that makes a South Florida house miserable comes straight down through the ceiling. We seal the attic floor, bring it to R-38 and keep the soffits breathing.

Attic Insulation in Palm Beach County

Why attic insulation matters in Palm Beach County

On a July afternoon the underside of a dark tile roof can push attic air well past 140°F. That heat radiates down onto the attic floor and conducts through whatever insulation is left — in a lot of Broward, Miami-Dade and Palm Beach homes, that is a few inches of settled fiberglass pushed around by cable installers and AC techs.

Our attic jobs start with air sealing: top plates, wire and plumbing penetrations, recessed lights, the attic hatch and the gaps around the air-handler platform. Then we install baffles so soffit vents stay open, and blow fiberglass or cellulose to a measured depth, with depth markers stapled to the trusses so you — and your inspector — can see what you paid for.

What's included

  • Air sealing at every ceiling penetration before a single bag is opened
  • Soffit baffles so the attic keeps breathing
  • R-38 recommended (R-30 is the Climate Zone 1 code minimum)
  • Depth markers and photos of the finished attic
  • Old, wet or rodent-fouled insulation vacuumed out first when needed

What it costs

Blown fiberglass to R-38 typically runs about $1.10–$1.90 per sq ft, roughly $2,200–$4,500 for a 2,000 sq ft home including air sealing and baffles. Every estimate is written and itemized — measured square footage, the R-value or thickness we will install, prep work and price — with alternatives side by side when there is more than one good answer.

Attic Insulation by city

References

FAQ

Questions, answered.

01How much attic insulation does a South Florida home need?

Broward, Miami-Dade and Palm Beach counties are all in Climate Zone 1 under the Florida Building Code, Energy Conservation, where the prescriptive ceiling minimum is R-30. We recommend R-38 — roughly 13 to 14 inches of blown fiberglass — because settling and thin spots at the eaves make an R-30 attic perform closer to R-24 within a few years.

02Should I remove the old insulation or add on top?

If it is dry, clean and free of rodent activity, topping up is usually the better value. If it is wet, moldy, compressed by foot traffic or contaminated by droppings, it should come out first — new insulation on top of a problem just buries it.

03Can you insulate around my air handler and ducts?

Yes. We seal and insulate around the platform and keep a clear service path to the unit so your AC tech can still reach the filter and drain line.

04How long does an attic job take?

A typical single-family attic top-up is one day. Removal plus reinstall usually takes two.

Free written estimates

Let's cool it down.

Tell us about the building. Homeowners, property managers, builders and general contractors across Broward, Miami-Dade and Palm Beach — one call covers the whole envelope.

Request a free estimate

Takes about 60 seconds. A real person follows up — usually the same day.

No obligation. Goes straight to our estimating team at bids@standard-insulation.com.

Call NowFree Estimate