
Insulation Removal in Haverhill
We install insulation removal across Haverhill — 33415, 33417 — and every job starts with photographs of what is actually there.
Removal is the first step whenever we find wet, moldy, compressed or rodent-fouled insulation in a Haverhill attic. Original roofs are often low-slope with a shallow attic — sometimes 18 inches at the eaves — and the insulation is a thin, dusty layer of old batts or rock wool, frequently disturbed by decades of rewiring and roof work.
We usually remove what is left, seal the ceiling plane and blow fiberglass as deep as the framing allows. On flat or low-slope sections where blowing is impractical, spray foam on the underside of the deck is often the only way to reach meaningful R-value.
Why insulation removal matters in Haverhill
Rats, roof leaks and storm damage all end the same way: insulation that is packed down, stained, smells and no longer insulates. Adding new material on top buries the problem. Removal gets the attic floor back to bare drywall so we can see and seal every gap.
Our removal crews use high-powered insulation vacuums, HEPA filtration and containment at the hatch. Once the attic is clear we sanitize where needed, air seal the ceiling plane and install fresh insulation to R-38. Mold remediation, where needed, is handled by licensed mold professionals under Florida law.
What's included
- Commercial vacuum extraction to bags outside
- Containment and floor protection at the access
- Rodent-fouled, wet and storm-damaged insulation
- Air sealing on the bare ceiling plane
- Fresh insulation installed the same week
What it costs
Removal typically runs $1.00–$2.00 per sq ft, plus reinstall. Every estimate is written and itemized — measured square footage, the R-value or thickness we will install, prep work and price — with alternatives side by side when there is more than one good answer.
Code & incentives
Haverhill homes are built and inspected under the Florida Building Code. For energy purposes all of Palm Beach County is Climate Zone 1, where the prescriptive minimum for ceilings is R-30. We design to R-38 because real attics settle, get walked on and run thin at the eaves. Palm Beach County sits outside the High-Velocity Hurricane Zone, but wind-borne debris rules still apply along the coast, and we treat every roof-deck job with the same care.
Electric service in Haverhill comes from Florida Power & Light (FPL). Insulation incentives change, so we check current programs before quoting — start with Florida Power & Light (FPL). For permits tied to remodels, additions or re-roofs, see the Palm Beach County government. You can confirm any contractor's license on the Florida DBPR license search.