
Attic Insulation in Juno Beach
Here is the short version for Juno Beach: most of the heat that makes a South Florida house miserable comes straight down through the ceiling. We seal the attic floor, bring it to R-38 and keep the soffits breathing.
In Juno Beach, the attic is where we start nearly every job. Salt air, wind-driven rain and constant sun are hard on roofs, so the attics we open near the water often show staining, compressed wet patches and corroded fasteners.
We start by finding and photographing moisture, remove anything that has been wet, and favor fiberglass or closed-cell foam that tolerate humidity. Ventilation stays open, and every penetration gets sealed so damp air stays out of the house.
Why attic insulation matters in Juno Beach
On a July afternoon the underside of a dark tile roof can push attic air well past 140°F. That heat radiates down onto the attic floor and conducts through whatever insulation is left — in a lot of Broward, Miami-Dade and Palm Beach homes, that is a few inches of settled fiberglass pushed around by cable installers and AC techs.
Our attic jobs start with air sealing: top plates, wire and plumbing penetrations, recessed lights, the attic hatch and the gaps around the air-handler platform. Then we install baffles so soffit vents stay open, and blow fiberglass or cellulose to a measured depth, with depth markers stapled to the trusses so you — and your inspector — can see what you paid for.
What's included
- Air sealing at every ceiling penetration before a single bag is opened
- Soffit baffles so the attic keeps breathing
- R-38 recommended (R-30 is the Climate Zone 1 code minimum)
- Depth markers and photos of the finished attic
- Old, wet or rodent-fouled insulation vacuumed out first when needed
What it costs
Blown fiberglass to R-38 typically runs about $1.10–$1.90 per sq ft, roughly $2,200–$4,500 for a 2,000 sq ft home including air sealing and baffles. Every estimate is written and itemized — measured square footage, the R-value or thickness we will install, prep work and price — with alternatives side by side when there is more than one good answer.
Code & incentives
Juno Beach homes are built and inspected under the Florida Building Code. For energy purposes all of Palm Beach County is Climate Zone 1, where the prescriptive minimum for ceilings is R-30. We design to R-38 because real attics settle, get walked on and run thin at the eaves. Palm Beach County sits outside the High-Velocity Hurricane Zone, but wind-borne debris rules still apply along the coast, and we treat every roof-deck job with the same care.
Electric service in Juno Beach comes from Florida Power & Light (FPL). Insulation incentives change, so we check current programs before quoting — start with Florida Power & Light (FPL). For permits tied to remodels, additions or re-roofs, see the Palm Beach County government. You can confirm any contractor's license on the Florida DBPR license search.