
Blown-In Insulation in Jupiter
If you live near the Jupiter Inlet Lighthouse, you have probably felt it: the back of the house runs warmer, the AC never quite catches up and the bill tells the rest of the story.
Blown-in fiberglass is our most-installed product in Jupiter because it fills around trusses, wires and odd framing the way batts never will. The air handler and most of the ductwork sit in the attic, usually under R-19 to R-30 of blown fiberglass that has been walked flat around the AC platform and pushed aside at the eaves.
For most of these homes the best value is air sealing plus a top-up to R-38, a radiant barrier on the rafters and sealed duct connections. If the roof is being replaced, open-cell foam on the deck becomes a strong option.
Why blown-in insulation matters in Jupiter
Loose-fill fills around trusses, wiring and the odd framing in a hip-roof attic far better than batts can. The catch is coverage: blown insulation only performs when it is installed to the bag-chart depth and density, with no bare spots at the eaves and no voids behind the air handler.
We blow from a truck-mounted machine with the hose run through the attic hatch — nothing tracked through your living room — and we mark the depth every few hundred square feet. Fiberglass resists moisture and does not feed mold; cellulose packs a little more R per inch and dampens sound. We will tell you which fits your attic.
What's included
- Blown fiberglass or cellulose, matched to your attic
- Installed to manufacturer depth and density
- Hose run from the truck — no bags through the house
- Pairs with air sealing and radiant barrier
- Fast: most attics done in a single day
What it costs
Typically $1.10–$1.90 per sq ft for fiberglass to R-38, depending on starting depth, access and air sealing scope. Every estimate is written and itemized — measured square footage, the R-value or thickness we will install, prep work and price — with alternatives side by side when there is more than one good answer.
Code & incentives
Jupiter homes are built and inspected under the Florida Building Code. For energy purposes all of Palm Beach County is Climate Zone 1, where the prescriptive minimum for ceilings is R-30. We design to R-38 because real attics settle, get walked on and run thin at the eaves. Palm Beach County sits outside the High-Velocity Hurricane Zone, but wind-borne debris rules still apply along the coast, and we treat every roof-deck job with the same care.
Electric service in Jupiter comes from Florida Power & Light (FPL). Insulation incentives change, so we check current programs before quoting — start with Florida Power & Light (FPL). For permits tied to remodels, additions or re-roofs, see the Palm Beach County government. You can confirm any contractor's license on the Florida DBPR license search.