
Spray Foam Insulation in Riviera Beach
We install spray foam insulation across Riviera Beach — 33404, 33407, 33418 — and every job starts with photographs of what is actually there.
Spray foam earns its cost in Riviera Beach when the ducts and air handler live in the attic or when there is no room to blow loose-fill. In a single afternoon we might see a 1940s cottage, a 1970s ranch, a new townhouse and a commercial build-out, each failing in its own way.
That variety is why every estimate starts with an on-site look. Older homes usually need removal and air sealing first; newer homes typically need a top-up and radiant barrier; commercial spaces get a specification-driven bid.
Why spray foam insulation matters in Riviera Beach
In a typical South Florida house the AC ductwork lives in the hottest place on the property. Foam on the roof deck changes that: the attic becomes a semi-conditioned space, duct losses fall sharply and humid outside air stops leaking in at the soffits and ridge.
Open-cell foam is lighter and more affordable and works well on most roof decks. Closed-cell is denser, adds racking strength and resists water, which is why we use it on metal buildings, flat roofs and below-grade or coastal assemblies. Every foam job includes ignition or thermal barrier compliance where the code requires it, and we coordinate with your roofer if the roof is being replaced.
What's included
- Open-cell or closed-cell, specified by assembly
- Unvented (conditioned) attic design per the Florida Building Code
- Brings ducts and air handler inside the envelope
- Ignition/thermal barrier compliance where required
- Fully air-sealed roofline — no more humid attic air
What it costs
Roughly $2.20–$6.50 per sq ft depending on foam type and thickness; a full roof-deck encapsulation on a 2,000 sq ft home often lands between $6,000 and $13,000. Every estimate is written and itemized — measured square footage, the R-value or thickness we will install, prep work and price — with alternatives side by side when there is more than one good answer.
Code & incentives
Riviera Beach homes are built and inspected under the Florida Building Code. For energy purposes all of Palm Beach County is Climate Zone 1, where the prescriptive minimum for ceilings is R-30. We design to R-38 because real attics settle, get walked on and run thin at the eaves. Palm Beach County sits outside the High-Velocity Hurricane Zone, but wind-borne debris rules still apply along the coast, and we treat every roof-deck job with the same care.
Electric service in Riviera Beach comes from Florida Power & Light (FPL). Insulation incentives change, so we check current programs before quoting — start with Florida Power & Light (FPL). For permits tied to remodels, additions or re-roofs, see the Palm Beach County government. You can confirm any contractor's license on the Florida DBPR license search.