Broward County · South Florida

Insulation Contractor in Franklin Park, FL

Spray foam, blown-in, batt, Fi-Foil, radiant barrier, and insulation removal for Franklin Park homes, businesses, and industrial buildings. Licensed, insured, and open 24/7.

  • Serving all of Franklin Park
  • Free written estimates
  • Open 24/7
  • Licensed & insured

If you own a home or a building in Franklin Park, your insulation is doing more work than almost anything else in the structure — and in most Franklin Park buildings we assess, it is not doing it well. Franklin Park sits in South Florida, in Broward County, where summer attic temperatures routinely climb past 130 degrees and the air outside is carrying enough moisture that every gap in your ceiling plane is pumping humidity into your living space.

Franklin Park is in the High-Velocity Hurricane Zone. Broward County carries Florida's strictest product approval and wind-borne debris requirements. Closed-cell spray foam adhered to the roof deck adds measurable uplift resistance to roof sheathing, and we install to HVHZ product approvals throughout Franklin Park.

Air sealing comes before insulation in Franklin Park

This is the part most Franklin Park homeowners have never had explained to them. Insulation resists heat conduction. It does absolutely nothing to stop air from moving through it. If we blow R-38 over a ceiling full of unsealed recessed light housings, plumbing penetrations, top plates, and an uninsulated attic hatch, you have paid for R-38 and you will experience something considerably less.

On every Franklin Park job we seal the ceiling plane first — penetrations foamed, can lights covered or replaced with airtight housings, the attic hatch weatherstripped and insulated, and bath fans verified to actually terminate outside rather than dumping humid air into the attic. Then we insulate. It adds a few hours and it changes the result substantially.

Humidity is half the problem in Franklin Park

People in Franklin Park describe the symptom as the house feeling clammy even when the thermostat reads 74. That is a humidity problem, and it usually traces back to air leakage rather than to the air conditioner.

Outdoor air in South Florida carries a lot of moisture. Every cubic foot of it that leaks into your house through the ceiling plane has to be dehumidified by your AC, which is why an air-sealed house feels dramatically better at the same thermostat setting. It's also why an oversized air conditioner makes Franklin Park homes feel worse — it satisfies the thermostat and shuts off before it has run long enough to actually pull moisture out of the air.

Commercial and industrial work in Franklin Park

We handle commercial and industrial insulation across Franklin Park and Broward County — offices, retail, restaurants, hotels, medical suites, warehouses, distribution, manufacturing, and cold storage.

That includes building envelope, mechanical and thermal insulation on ductwork and piping, chilled water condensation control, fire-rated assemblies built to the listed detail, and metal building systems. Carrying all three scopes under one contractor eliminates the interface gaps that cause most failed inspections. Occupied buildings in Franklin Park get night and weekend crews with containment and HEPA filtration.

All Services in Franklin Park

Every Type of Insulation Available in Franklin Park, FL

Residential, commercial, and industrial — the complete envelope under one contractor.

Property Types

Who We Serve in Franklin Park

Insulation types in Franklin Park

Every insulation type we install in Franklin Park

Each one has its own Franklin Park page with local pricing, Florida code requirements and FAQs.

Franklin Park Insulation FAQs

How much does insulation cost in Franklin Park, FL?

Most Franklin Park attic insulation projects fall between $1.50 and $4.50 per square foot installed. A typical 2,000 sq ft Franklin Park home runs roughly $2,200–$4,500 for a blown-in top-up to R-38, and $6,000–$13,000 for a full closed-cell spray foam roof deck encapsulation. Insulation removal adds about $1.00–$2.00 per square foot. Standard Insulation gives free, written, itemized estimates throughout Franklin Park and Broward County — call (561) 975-6204.

What R-value do I need in a Franklin Park attic?

Franklin Park falls in Florida Climate Zone 1 under the Florida Building Code, Energy Conservation (8th Edition). That means R-30 minimum for attics, with R-38 being the practical target for real comfort and utility savings. Many Franklin Park homes built before 2005 are still measuring R-11 to R-19, which is a large part of why their summer bills are so high.

Do you offer spray foam insulation in Franklin Park?

Yes. We install both open-cell and closed-cell spray foam throughout Franklin Park, Broward County. Closed-cell on the roof deck is the strongest option here — it air seals, controls humidity, brings your ducts into conditioned space, and adds measurable uplift resistance to your roof sheathing, which matters in the High-Velocity Hurricane Zone.

How fast can you get to Franklin Park?

We answer the phone 24 hours a day, 7 days a week. In Broward County we can usually be on site for a free assessment within 24 to 48 hours, and emergency insulation removal after a roof leak or storm gets same-day priority whenever we can make it happen.

Do you handle commercial insulation in Franklin Park?

Yes — offices, retail, restaurants, hotels, medical, warehouses, distribution, manufacturing, and cold storage throughout Franklin Park and Broward County. We carry envelope, mechanical, and fire-rated scopes, and we work nights and weekends in occupied buildings with containment and HEPA filtration.

Are you licensed and insured to work in Franklin Park?

Yes. Standard Insulation is a licensed Florida insulation contractor carrying general liability and workers' compensation coverage, and we work throughout Franklin Park and all of Broward County. Certificates of insurance are provided to homeowners, general contractors, and property managers on request before any work begins.

Can insulation lower my electric bill in Franklin Park?

Cooling is roughly half of a typical Franklin Park electric bill. Bringing an under-insulated attic from R-11 up to a properly air-sealed R-38 commonly cuts the cooling portion by 20 to 30 percent — and more if your ductwork is in the attic and we add a radiant barrier. On a $300 summer bill that's usually $30 to $45 a month back in your pocket.

What is the best insulation for a Franklin Park home?

It depends on your building and your budget, and we'll tell you honestly which one applies. If your attic is at R-13 and you want the most improvement per dollar, blown-in fiberglass to R-38 with proper air sealing is the answer. If your ducts are in the attic and you want humidity control and the biggest total comfort win, closed-cell spray foam on the roof deck is the answer. If your roof is more than twelve years old, do the roof first — we'll say so.

Get Your Free Insulation Estimate

Answer 6 quick questions. We call back fast — we're open 24/7. No pressure, no obligation, no charge for the estimate.

1 · Where is the job?
We serve every city in all 67 Florida counties.
2 · What kind of property?
3 · Which insulation services do you need? *

Prefer to talk? Call (561) 975-6204 — we answer 24/7. Or email bids@standard-insulation.com.

Free Insulation Estimate in Franklin Park

No obligation, no charge. Call (561) 975-6204 — we're open 24/7.

Open 24/7 · 5827 Plunkett St, Hollywood, FL 33023 · bids@standard-insulation.com

📞 Contact Us Now 💬 Free Estimate
📞 Contact Us Now 💬 Free Estimate