Franklin County · the Florida Panhandle

Insulation Contractor in St. George Island, FL

Spray foam, blown-in, batt, Fi-Foil, radiant barrier, and insulation removal for St. George Island homes, businesses, and industrial buildings. Licensed, insured, and open 24/7.

  • Serving all of St. George Island
  • Free written estimates
  • Open 24/7
  • Licensed & insured

Standard Insulation works throughout St. George Island, Franklin County, installing the full range of insulation systems that actually make sense in the Florida Panhandle. The building stock in St. George Island spans several decades of construction practice, and the insulation situation we find varies enormously from one street to the next — but the pattern is consistent: under-depth attics, unsealed ceiling planes, and ductwork baking in a superheated attic.

What we find in St. George Island attics

The typical assessment in St. George Island turns up one of a few situations. Older construction usually has original blown fiberglass that has settled well below its installed depth — what was R-19 in 1985 is frequently measuring R-11 to R-13 today, with bare joists showing through in places. Mid-era homes often have adequate depth in the center of the attic and almost nothing at the perimeter, because the original crew couldn't reach the eaves and nobody checked.

Newer St. George Island construction usually meets code on paper, but code minimum and comfortable are not the same thing, and builder-grade installation quality varies widely. We measure in multiple locations and photograph what we find so you're looking at evidence, not opinions.

Humidity is half the problem in St. George Island

People in St. George Island describe the symptom as the house feeling clammy even when the thermostat reads 74. That is a humidity problem, and it usually traces back to air leakage rather than to the air conditioner.

Outdoor air in the Florida Panhandle carries a lot of moisture. Every cubic foot of it that leaks into your house through the ceiling plane has to be dehumidified by your AC, which is why an air-sealed house feels dramatically better at the same thermostat setting. It's also why an oversized air conditioner makes St. George Island homes feel worse — it satisfies the thermostat and shuts off before it has run long enough to actually pull moisture out of the air.

Commercial and industrial work in St. George Island

We handle commercial and industrial insulation across St. George Island and Franklin County — offices, retail, restaurants, hotels, medical suites, warehouses, distribution, manufacturing, and cold storage.

That includes building envelope, mechanical and thermal insulation on ductwork and piping, chilled water condensation control, fire-rated assemblies built to the listed detail, and metal building systems. Carrying all three scopes under one contractor eliminates the interface gaps that cause most failed inspections. Occupied buildings in St. George Island get night and weekend crews with containment and HEPA filtration.

All Services in St. George Island

Every Type of Insulation Available in St. George Island, FL

Residential, commercial, and industrial — the complete envelope under one contractor.

Property Types

Who We Serve in St. George Island

Insulation types in St. George Island

Every insulation type we install in St. George Island

Each one has its own St. George Island page with local pricing, Florida code requirements and FAQs.

St. George Island Insulation FAQs

How much does insulation cost in St. George Island, FL?

Most St. George Island attic insulation projects fall between $1.50 and $4.50 per square foot installed. A typical 2,000 sq ft St. George Island home runs roughly $2,200–$4,500 for a blown-in top-up to R-38, and $6,000–$13,000 for a full closed-cell spray foam roof deck encapsulation. Insulation removal adds about $1.00–$2.00 per square foot. Standard Insulation gives free, written, itemized estimates throughout St. George Island and Franklin County — call (561) 975-6204.

What R-value do I need in a St. George Island attic?

St. George Island falls in Florida Climate Zone 2 under the Florida Building Code, Energy Conservation (8th Edition). That means R-38 minimum for attics, with R-49 being the practical target for real comfort and utility savings. Many St. George Island homes built before 2005 are still measuring R-11 to R-19, which is a large part of why their summer bills are so high.

Do you offer spray foam insulation in St. George Island?

Yes. We install both open-cell and closed-cell spray foam throughout St. George Island, Franklin County. Closed-cell on the roof deck is the strongest option here — it air seals, controls humidity, brings your ducts into conditioned space, and adds measurable uplift resistance to your roof sheathing, which matters in a hurricane-exposed part of Florida.

How fast can you get to St. George Island?

We answer the phone 24 hours a day, 7 days a week. In Franklin County we can usually be on site for a free assessment within 24 to 48 hours, and emergency insulation removal after a roof leak or storm gets same-day priority whenever we can make it happen.

Do you handle commercial insulation in St. George Island?

Yes — offices, retail, restaurants, hotels, medical, warehouses, distribution, manufacturing, and cold storage throughout St. George Island and Franklin County. We carry envelope, mechanical, and fire-rated scopes, and we work nights and weekends in occupied buildings with containment and HEPA filtration.

Are you licensed and insured to work in St. George Island?

Yes. Standard Insulation is a licensed Florida insulation contractor carrying general liability and workers' compensation coverage, and we work throughout St. George Island and all of Franklin County. Certificates of insurance are provided to homeowners, general contractors, and property managers on request before any work begins.

Can insulation lower my electric bill in St. George Island?

Cooling is roughly half of a typical St. George Island electric bill. Bringing an under-insulated attic from R-11 up to a properly air-sealed R-38 commonly cuts the cooling portion by 20 to 30 percent — and more if your ductwork is in the attic and we add a radiant barrier. On a $300 summer bill that's usually $30 to $45 a month back in your pocket.

What is the best insulation for a St. George Island home?

It depends on your building and your budget, and we'll tell you honestly which one applies. If your attic is at R-13 and you want the most improvement per dollar, blown-in fiberglass to R-38 with proper air sealing is the answer. If your ducts are in the attic and you want humidity control and the biggest total comfort win, closed-cell spray foam on the roof deck is the answer. If your roof is more than twelve years old, do the roof first — we'll say so.

Get Your Free Insulation Estimate

Answer 6 quick questions. We call back fast — we're open 24/7. No pressure, no obligation, no charge for the estimate.

1 · Where is the job?
We serve every city in all 67 Florida counties.
2 · What kind of property?
3 · Which insulation services do you need? *

Prefer to talk? Call (561) 975-6204 — we answer 24/7. Or email bids@standard-insulation.com.

Free Insulation Estimate in St. George Island

No obligation, no charge. Call (561) 975-6204 — we're open 24/7.

Open 24/7 · 5827 Plunkett St, Hollywood, FL 33023 · bids@standard-insulation.com

📞 Contact Us Now 💬 Free Estimate
📞 Contact Us Now 💬 Free Estimate