Insulation for Cutler Bay homes
Most Cutler Bay homeowners call us about one room: the bedroom over the garage, the west-facing office, the top-floor unit that never cools. Nine times out of ten the fix is overhead — in the attic, the roof deck and the gaps nobody sealed.
Most of what we see in Cutler Bay is 1950s–1970s concrete block ranches with low-slope roofs, shallow attics and whatever insulation survived six decades of summers. Original roofs are often low-slope with a shallow attic — sometimes 18 inches at the eaves — and the insulation is a thin, dusty layer of old batts or rock wool, frequently disturbed by decades of rewiring and roof work.
We usually remove what is left, seal the ceiling plane and blow fiberglass as deep as the framing allows. On flat or low-slope sections where blowing is impractical, spray foam on the underside of the deck is often the only way to reach meaningful R-value.
What we install in Cutler Bay
Every system below has its own Cutler Bay page with local notes, pricing and FAQs.
Code, climate & rebates
Cutler Bay homes are built and inspected under the Florida Building Code. For energy purposes all of Miami-Dade County is Climate Zone 1, where the prescriptive minimum for ceilings is R-30. We design to R-38 because real attics settle, get walked on and run thin at the eaves. Miami-Dade County is also part of the High-Velocity Hurricane Zone, so roof-deck work is always coordinated with the roofing approvals.
Electric service in Cutler Bay comes from Florida Power & Light (FPL). Insulation incentives change, so we check current programs before quoting — start with Florida Power & Light (FPL). For permits tied to remodels, additions or re-roofs, see the Miami-Dade County government. You can confirm any contractor's license on the Florida DBPR license search.
Cutler Bay insulation pricing
| System | Typical installed range |
|---|---|
| Blown fiberglass to R-38 (incl. air sealing) | $1.10–$1.90 / sq ft |
| Insulation removal (vacuum extraction) | $1.00–$2.00 / sq ft |
| Radiant barrier on rafters | $0.60–$1.40 / sq ft |
| Open-cell spray foam, roof deck | $2.20–$3.75 / sq ft |
| Closed-cell spray foam | $3.50–$6.50 / sq ft |
| Batts in open framing | $0.90–$1.80 / sq ft |
Typical Cutler Bay ranges for 2026. Your written estimate is based on measured square footage, access, existing conditions and the system you choose.
How a Cutler Bay job runs
- Call or send the form. We answer 24/7 and book a visit — usually within 24–48 hours in Cutler Bay.
- Attic assessment. Depth, moisture, rodents, ducts, ventilation and air leaks — photographed.
- Written options. Systems, R-values and prices side by side.
- Install day. Containment, air sealing, insulation to measured depth, depth markers.
- Walkthrough. Photos and paperwork for your records, HOA or inspector.
Every Cutler Bay job ends with depth markers, photos and a walkthrough. If something in the attic needs a roofer, a pest company or an electrician first, we will tell you — before you spend money on insulation.
From Cutler Bay to our office
We are based at 5827 Plunkett St, Hollywood, FL 33023. Here is the route from Cutler Bay: